Find Plumbers Directory | Find Plumbing Services | Find Sewer Septic Services

5 EASY STEPS IN INSTALLING A NEW TOILET

Installing a new toilet is a relatively easy task and could be done in a couple of hours.

For the most part, toilets come with the necessary gears, nonetheless you might have to buy a few parts like toilet tank, wax ring, toilet seat, channel pliers, screw driver and bucket.

First shut off the water connection to the toilet removing any stagnant water.

With the help of channel pliers wrench, unscrew the nut of the water line that is fastened to the ball cock valve beneath the tank on the left side. Next using a crescent wrench, unscrew the two nuts that is gripping the bowl to the floor flange. Now take out the old toilet.

That being done, you are ready for installation of the new toilet. Place the two bolts on the side holes of the flange with bolt heads on the flange. Place some wax in this spot in an attempt to grip the bolts vertically and diagonally from each other. Place the new wax ring upon the flange with the flat side up, if tapered.

After setting the new toilet bowl straight down centering on the wax ring with the bolts holding each side of the bowl. Sit on the bowl with your weight bowl flushing the floor. Tighten with metal washers and nuts making sure not to over tighten them as it could crack the bowl.

Next place the two inch rubber gasket upon the tank where it sets on the bowl placing rubber washers on the bolts such that they are on the inside of the tank. Place the tank and set it on the bowl. Now sit on the bowl facing the wall. Place the bolts from inside the tank, place metal washers, nuts and tighten.

Holding the tank level tighten it bringing down the tank level. With the help of a screw driver on the insides of the tank use the end wrench to back up the nut below the bowl. Restore water supply and check for leaks securing the bolts to the floor.

Blog Post provided by:  Birmingham AL Plumbers